rear axle

英 [rɪə(r) ˈæksl] 美 [rɪr ˈæksl]

网络  后桥; 后轴; 汽车后桥; 后轮轴; 驱动桥

机械



双语例句

  1. For removing and installing the rear axle.
    用于拆卸和安装后轴。
  2. The quenching distortion of rear axle spiral bevel gear used in FLAT tractor is studied in this paper.
    研究了菲亚特拖拉机后桥大圆锥螺旋齿轮淬火变形规律,分析了原淬火压模存在的问题。
  3. Tighten lock nut from camber eccentric to the prescribed tightening torque tightening torques for rear axle.
    将外倾角偏心装置的锁紧螺母紧固至规定的拧紧力矩后轴的拧紧力矩。
  4. When lowering, the engine must not rest on the rear axle cross member.
    降低发动机时,发动机不得位于后轴横梁上。
  5. Vacuum brake booster, ventilated brake discs at front and rear axle.
    真空制动助力器,前、后轴通风式制动盘。
  6. Detach the engine cable at the rear axle carrier.
    拆开后桥托架上的发动机电缆。
  7. Additional braces above and below the engine bay and under the rear axle add further rigidity to the spaceframe.
    发动机舱上下和后轴底部的防护梁进一步增加了车身刚性。
  8. The rack-and-pinion steering is sharp, and the torsion beam rear axle gives the car a grown-up feel.
    齿条式齿轮转向是敏锐的,而尾轴扭力梁给车子有大车的感觉。
  9. A software function that allows you to read the front and rear axle loads on trucks equipped with EBS and air suspension.
    使用该软件功能,您可以在安装了EBS和空气悬挂的卡车上读取前、后轴的载荷。
  10. Remove axle strut on wheel carrier on the rear axle side sections.
    拆卸后轴侧面车轮托架上的轴支柱。
  11. Analysis and Improvement of Rear Axle Housing Fatigue Life Based on Vehicle Dynamics Simulation
    基于整车动力学仿真的后桥壳疲劳寿命分析与改进
  12. To further improve motoring sensation, BMW introduces a new kind of rear axle in1990.
    为了进一步提高其受欢迎程度,BMW于1990年推出了一种新的后轮轴。
  13. The rear axle is one of the key components for automobiles, which suffers from complex forces;
    后桥是汽车的关键部件之一,受力复杂;
  14. The wheel carrier on the rear axle has been modified.
    后轴上的车轮托架已进行改进。
  15. Observe prescribed tightening sequence so as not to twist the rear axle.
    请遵守规定的紧固顺序,以免使后轴扭曲。
  16. Final drive on rear axle.
    后轴上的主减速器。
  17. Santana Rear Axle Strain Observation System during Fatigue Test Crack Propagation
    桑塔纳轿车后桥疲劳试验中裂纹扩展应变监测系统
  18. The rear axle is stationary, and is bolted rigidly to the main frame.
    后轴是固定的,用螺栓刚性固定在主机架上。
  19. Can only be fitted on rear axle.
    不能安装在后轴上。
  20. On all vehicles it is important to remember that the rear axle dictates the position of the front wheels.
    在所有车辆重要的是要记住,后轴决定了前轮的位置。
  21. Two cables are routed from the turnbuckle to the parking brakes on the rear axle.
    从螺旋扣到后轴驻车制动布置了两条拉线。
  22. Remove the brake cable from the guide of the rear axle housing and loosen it by moving it to and fro.
    从后轴壳导套上拆下制动器拉线并来回移动将其松开。
  23. Control of Heat Treatment Distortion of Auto Rear Axle Spiral Bevel Gear
    汽车后桥螺旋伞齿轮热处理畸变的控制
  24. Replace screws at front and rear axle after each removal.
    每次拆卸后更换前轴和后轴处的螺钉。
  25. Observe tightening torques tightening torques for rear axle.
    遵守拧紧力矩后轴拧紧力矩。
  26. At VCU, by whenever the front wheel to lose traction, the dip in oil in turn of the disc-type torque transmission to the rear axle vehicles.
    在VCU中,每当前轮失去牵引力时,浸在硅油中的交替式盘片会将扭矩传递到汽车的后桥。
  27. Identical part on front and rear axle.
    前后轴上的零件相同。
  28. Different types can be used on the front axle and rear axle.
    前桥和后桥上可以使用不同的类型。
  29. Ventilated brake discs at front and rear axle.
    前、后轴通风式制动盘。
  30. However, no more than60kg difference in total between front axle and rear axle.
    但是,前轴和后轴之间的总差值不能大于60kg。